Table of Contents
Advertisement
Removing the 6-Position Cell Holder and the Single Cell Holder
Installing Accessory Cell Holders
External Printers
Thermo Scientific
Note If the cell holder is not aligned correctly, you will not be able to tighten the
thumbscrews.
To remove the 6-Position Cell Holder and the Single Cell Holder
1. Open the sample compartment door and let it rest on its hinge.
2. With one hand, loosen the captive thumbscrew.
3. With your other hand, pull straight up on the cell holder and lift it out of the sample
compartment
4. Close the sample compartment door.
Make sure that you have the correct cell holder baseplate installed.
Note To use 100 mm long pathlength cells, you must install the Single Cell Holder
baseplate.
See
"Cell Holder Configurations"
be created for your instrument.
Each of the Cell Holders needs to be installed on either a single-cell baseplate or a multi-cell
baseplate by removing the cell holder(s) secured to the baseplate. Each cell holder has a captive
screw in the bottom of the holder that secures the holder to the baseplate. Use a flat blade
screwdriver to loosen the captive screw from the baseplate and lift the cell holder from the
baseplate. Then insert the new cell holder into the appropriate position and secure it to the
baseplate by tightening the captive screw.
Note Remove the baseplate from the instrument before removing or installing cell
holders.
See
"Installing the 6-Position Cell Holder and the Single Cell Holder"
instructions on installing the complete accessory assembly in your instrument.
Your spectrophotometer is able to print to external desktop printers supporting HP PCL 5.0
format and later.
Note PCL format does not support HP "Windows" printers.
on
page 13
for the different cell holder accessories that can
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
3
Accessories
External Printers
on
page 15
for
17
Hide quick links:
Advertisement
Table of Contents
