Table of Contents
Advertisement
16
Multiwavelength
Setting Up Test Parameters
Setting Up Test Parameters
Adding Wavelengths and Factors
76
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
2. Highlight the test to recall and press Enter to display its parameters.
This screen provides these capabilities:
•
Setting Up Test Parameters
•
Cell Correction
•
Saving a Test
• Viewing the list of stored tests
•
Taking Measurements
To set up test parameters
In the Multiwavelength screen, highlight the desired parameter.
See the procedures below for instructions on
If you have previously selected the wavelengths to measure, press Save Test to save the test or
Run Test to measure a blank or samples.
If you have not selected the wavelengths, you can add wavelengths and factors as shown
below.
Note If Cell Correction is ON, you must run the Setup Correction application before you
can access Run Test or Measure Samples.
Note If Auto Save Data is ON, you must enter a Data File Name before you can access
Run Test or Measure Samples.
Note You can enter factors only when the measurement mode is set to
Concentration/Factor.
To add wavelengths and factors
1. Press Set nms.
adding
or
deleting
wavelengths and factors.
Thermo Scientific
Hide quick links:
Advertisement
Table of Contents
