15
Scanning
Setting Up Test Parameters
Setting Up Test Parameters
Collecting a Baseline Scan
66
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
The parameters for the selected test appear.
This screen provides these capabilities:
•
Setting Up Test Parameters
• Setting up Cell Correction
To set up test parameters
1. Highlight the desired parameter.
2. When the parameters are set, press Save Test to save the test or Run Test to measure a
blank or a sample.
Note If Cell Correction is ON, you must run the Setup Correction application before
you can access Run Test or Measure Samples.
Note If Auto Save Data is ON, you must enter a Data File Name before you can
access Run Test or Measure Samples.
Note If a 6-Position Cell Holder is installed, be sure to place the blank in the B position.
The instrument always uses the B position to collect the baseline.
To collect a baseline scan
1. Press Run Test.
Thermo Scientific