17
Absorbance Ratio
Setting Up Test Parameters
Setting Up Test Parameters
Measuring Samples
80
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
2. Highlight the test to recall and press Enter.
This screen provides these capabilities:
•
Setting Up Test Parameters
•
Cell Correction
•
Saving a Test
• Viewing the list of stored tests
•
Measuring a Blank
To set up test parameters
1. In the Absorbance Ratio screen, highlight the desired parameter.
2. When the parameters are set, press Save Test to save the test or Run Test to measure a
blank or samples.
Note If Cell Correction is ON, you must run the Setup Correction application before
you can access Run Test or Measure Samples.
Note If Auto Save Data is ON, you must enter a Data File Name before you can
access Run Test or Measure Samples.
Thermo Scientific