12
Abs and %T Measurements—Advanced A-%T-C
Recalling a Test
Recalling a Test
Setting Up Test Parameters
Taking Measurements
54
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
To recall a test
1. In the Advanced A %T C screen, press Stored Tests.
2. Highlight the test you want to recall and press Enter.
Use this screen for:
•
Setting Up Test Parameters
•
Cell Correction
•
Saving a Test
• Viewing the list of stored tests
•
Taking Measurements
To set up test parameters
1. Highlight the desired parameter.
Some parameters appear only if you select one of the concentration modes, while others
appear regardless of the selected measurement mode. See
complete list.
2. When the parameters are set, press Save Test to save the test or Measure Sample to
measure a blank or samples.
To take measurements automatically (using Auto 6 or Auto 3)
1. Press Run Sample.
2. Install the blank and samples.
3. Press Measure Sample.
To take measurements manually (using Manual 6 or Single Cell Holder)
1. Press Run Sample.
2. When prompted, place the blank and samples into the cell holder.
If the 6-Position Cell Holder is installed, place the blank in the B position and the
samples in positions 1 to 5.
"Parameters"
on
page 125
Thermo Scientific
for a