Table of Contents
Advertisement
19
3-Point Net
Recalling a Test
Recalling a Test
Setting Up Test Parameters
Taking Measurements
88
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
To recall a test
1. Press Stored Tests.
2. Highlight the test to recall and press Enter to display its parameters.
This screen provides these capabilities:
•
Setting Up Test Parameters
•
Cell Correction
•
Saving a Test
• Viewing the list of stored tests
•
Taking Measurements
To set up test parameters
1. Highlight the desired parameter.
2. When the parameters are set, press Save Test to save the test or Run Test to measure a
blank or samples.
Note If Cell Correction is ON, you must run the Setup Correction application before
you can access Run Test or Measure Samples.
Note If Auto Save Data is ON, you must enter a Data File Name before you can
access Run Test or Measure Samples.
To take measurements automatically (Auto 6 or Auto 3)
1. With the 3-Point Net Setup screen displayed and the parameters set, press Run Test to
display the 3-Point Net measurement screen.
Thermo Scientific
Hide quick links:
Advertisement
Table of Contents
