3-Point Net
Thermo Scientific
The 3-Point Net application lets you determine the height of a peak based on a sloping
baseline drawn between two wavelengths on either side of the peak. This type of analysis is
beneficial when the precise peak height is needed for a particular assay. A factor can be
multiplied by the measured peak height to give the concentration of the measured analyte in
the appropriate concentration units.
Use 3-Point Net for:
•
Recalling a Test
•
Setting Up Test Parameters
•
Cell Correction
•
Taking Measurements
To get started, press Test, highlight 3-Point Net and press Enter.
Note If Cell Correction is ON, you must run the Setup Correction application before you
can access Run Test or Measure Samples.
Note If Auto Save Data is ON, you must enter a Data File Name before you can access
Run Test or Measure Samples.
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
19
87