No Ap Auto-Tagging - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

no ap
To delete the lock or unlock the access point, use the following command.
ruckus(config)# no ap <mac> lock
Syntax Description
This command uses the following syntax:
mac: AP MAC address
lock: Unlock AP
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# no ap 50:A7:33:24:EA:00

no ap auto-tagging

To disable auto tagging of critical access points, use the following command.
ruckus(config)# no ap auto-tagging <enable>
Syntax Description
This command uses the following syntax:
enable: Disable the auto tagging for critical access point
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# no ap auto-tagging enable
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71292-001 Rev A
Configuration Commands (e - r)
no ap
273