Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual page 77

Table 24. Commands related to ruckus(config-cgf-service) profile
Syntax and Type
ruckus(config-cgf-service)# cdr-
retry
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-apn-network-id
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-apn-op-id
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-apn-sel-mode
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-charging-sel-mode
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-diag
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-dyn-addr-flag
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-local-record-sn
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-msisdn
Type: Privileged
ruckus(config-cgf-service)# cdr-
send-node-id
Type: Privileged
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
Parameters (if any)
<retry-times>
Configuration Commands (a - d)
Description
Sets the CDR retries.
Enables in sending the APN
network identifier to the CDR.
Enables sending the APN operator
identifier.
Enables sending the APN
selection mode.
Enables sending the charging
characteristic selection mode.
Enables sending the diagnostic to
the CDR.
Enables in sending the dynamic
mode address flag.
Enables in sending the local record
sequence number.
Enables in sending the MSISDN.
Enables in sending the node ID to
the CDR.
cgf-service
77