Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual page 106

Table 36. Commands related to ruckus(config-domain-3rd-zone-wlan)
Syntax and Type
ruckus(config-domain-3rd-zone-
wlan)# no
Type: Privileged
ruckus(config-domain-3rd-zone-
wlan)# vlan-type
Type: Privileged
Table 37 lists the related domain-zone configuration commands.
Table 37. Commands related to ruckus(config-domain-zone)
Syntax and Type
ruckus(config-domain-zone)# aaa
Type: Privileged
ruckus(config-domain-zone)# adj-
threshold
Type: Privileged
ruckus(config-domain-zone)# ap-
firmware
Type: Privileged
ruckus(config-domain-zone)# ap-
group
Type: Privileged
ruckus(config-domain-zone)# ap-
ip-mode
Type: Privileged
ruckus(config-domain-zone)# ap-
logon
Type: Privileged
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
Parameters (if any)
access-vlan
acct-server
acct-service-profile
acct-ttg-session
bypass-cna
preserve-all
qinq <s-vlan-id>
Parameters (if any)
<name>
2.4g ${value}
5g ${value}
Value is minimum = 1 and
maximum = 100
<ap-firmware>
<name>
[ ipv4 | ipv6 |dual]
<logon-id>
Configuration Commands (a - d)
Description
Disables or deletes the
configurations that have been set.
Enables dynamic VLAN.
Description
Creates or updates the AAA server
configuration.
Sets the adjacent radio threshold
of the client load balancing.
Sets the AP firmware.
Creates or updates the AP group
configuration.
Sets the AP IP mode to either IPv4
or IPv6.
Sets the login ID for the AP
administrator.
domain
106