Hlr-Service - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

Table 76. Commands related to ruckus(config-hlr-mnc-ndc)
Syntax and Type
ruckus(config-hlr-mnc-ndc)# ndc
Type: Privileged

hlr-service

To setup the HLR service MNC to NDC mapping configuration, use the following
command.
ruckus(config)# hlr-service <name>
Syntax Description
This command uses the following syntax:
name: Name of the HLR service
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# hlr-service hlr2
Related Commands
• Table 77
• Table 78
• Table 79
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71292-001 Rev A
Parameters (if any)
<ndc>
lists the related hlr-service configuration commands.
lists the related hlr service sccp gtt configuration commands.
lists the related hlr service sctp configuration commands.
Configuration Commands (e - r)
Description
Sets the network destination
code.
hlr-service
202