Cgf-Service - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

cgf-service

To setup the CGF service configuration, use the following command:
ruckus(config)# cgf-service <name>
Syntax Description
This command uses the following syntax:
name: CGF service name
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# cgf-service charge-ser
Related Commands
• Table 24
• Table 25
• Table 26
Table 24 lists the related cgf-service profile configuration commands.
Table 24. Commands related to ruckus(config-cgf-service) profile
Syntax and Type
ruckus(config-cgf-service)# auto-
export-ftp
Type: Privileged
ruckus(config-cgf-service)# cdr-
node-id
Type: Privileged
ruckus(config-cgf-service)# cdr-
response-timeout
Type: Privileged
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
lists the related cgf-service profile configuration commands.
lists the related cgf-service-ftp-server configuration commands.
lists the related cgf-service-server configuration commands.
Parameters (if any)
<node-id>
<seconds>
Configuration Commands (a - d)
Description
Enables the auto export through
FTP. To view this command
execute charging-mode
command with the option as both.
Enables the node ID. The length
range is between 1 and 20.
Sets the CDR response timeout.
cgf-service
76