Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual page 63

Example
ruckus(config)# ap-auto-tagging enable
ruckus(config)# ap-auto-tagging rule daily-threshold 90 g
Related Commands
Table 17 lists the related to ap-auto-tagging configuration commands.
Table 17. Commands related to ruckus(config-ap-auto-tagging)
Syntax and Type
ruckus(config-ap-auto-tagging)#
do
Type: Privileged
ruckus(config-ap-auto-tagging)#
enable
Type: Privileged
ruckus(config-ap-auto-tagging)#
end
Type: Privileged
ruckus(config-ap-auto-tagging)#
exit
Type: Privileged
ruckus(config-ap-auto-tagging)#
help
Type: Privileged
ruckus(config-ap-auto-tagging)#
no
Type: Privileged
ruckus(config-ap-auto-tagging)#
rule
Type: Privileged
ruckus(config-ap-auto-tagging)#
threshold
Type: Privileged
ruckus(config-ap-auto-tagging)#
unit
Type: Privileged
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
Parameters (if any)
<enable>
<daily-threshold>
<threshold>
[ m | g ]
Configuration Commands (a - d)
Description
Executes the do command.
Enables the auto tagging for
critical APs.
Ends the current configuration
session and returns to privileged
EXEC mode.
Exits from the EXEC.
Displays the help.
Disables the auto tagging for
critical APs.
Sets the auto tagging rule to daily
traffic bytes, which exceeds the
threshold rule.
Sets the threshold value.
Sets the unit to either megabytes
or gigabytes.
ap-auto-tagging
63