Show Tlsv1-State - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

show tlsv1-state

To view tlsv1 support state, use the following command:
ruckus(debug)# show tlsv1-state
Syntax Description
This command has no arguments or keywords.
Default
This command has no default settings.
Command Mode
Debug
Example
ruckus(debug)# show tlsv1-state
strict-wfa-compliance
To enable WFA compliance, use the following command:
ruckus(debug)# no strict-wfa-compliance
NOTE: Its is highly recommended that the user contacts Ruckus customer support
before enabling / disabling this CLI command.
Syntax Description
This command has no arguments or keywords.
Default
This command has no default settings.
Command Mode
Debug
Example
ruckus(debug)# strict-wfa-compliance
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
Debug Commands
show tlsv1-state
462