Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual page 432

Table 165. Commands related to ruckus(config-zone-wlan)
Syntax and Type
ruckus(config-zone-wlan)#
hotspot2
Type: Privileged
ruckus(config-zone-wlan)#
hotspot20-osu-support
Type: Privileged
ruckus(config-zone-wlan)#
inactivity-timeout
Type: Privileged
ruckus(config-zone-wlan)# l2-acl
Type: Privileged
ruckus(config-zone-wlan)# mac-
address-format
Type: Privileged
ruckus(config-zone-wlan)# mac-
auth
Type: Privileged
ruckus(config-zone-wlan)# max-
clients
Type: Privileged
ruckus(config-zone-wlan)# mgmt-
tx-rate
Type: Privileged
ruckus(config-zone-wlan)#
mobility-domain-id
Type: Privileged
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
Parameters (if any)
<name>
<number>
[ <ACL Name> ]
<password>
<number>
[ 11mbps | 1mbps |
54mbps | 24mbps |
36mbps | 12mbps |
5.5mbps | 9mbps |
48mbps | 2mbps |
18mbps | 6mbps ]
<number>: ID number
(1-65535)
Configuration Commands (s - z)
Description
Sets the hotspot 2.0 configuration.
Enables the hotspot 2.0 device
registration from the guest portal.
Sets the inactivity timeout.
Terminates idle user sessions after
the specified seconds of inactivity.
Sets the layer 2 access control list.
Sets the MAC address format.
Sets the MAC authentication.
Sets the maximum clients. Allows
clients per AP radio to associate
with this WLAN. Range is between
1 and 512.
Sets the management Tx rates.
Sets the mobility domain identifier
(for 802.11r).
zone
432