User-Agent-Blacklist - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

user-agent-blacklist

To create and update the user agent blacklisted configuration, use the following
command.
ruckus(config)# user-agent-blacklist <name>
Syntax Description
This command uses the following syntax:
name: Name of the user agent blacklisted
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# user-agent-blacklist user-agent-blacklist
ruckus(config-user-agent-blacklist)#
Related Commands
Table 130
Table 130. Commands related to ruckus(config-user-agent-blacklist)
Syntax and Type
ruckus(config-user-agent-
blacklist)# do
Type: Privileged
ruckus(config-user-agent-
blacklist)# end
Type: Privileged
ruckus(config-user-agent-
blacklist)# error
Type: Privileged
ruckus(config-user-agent-
blacklist)# error-message
Type: Privileged
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
lists the related user-agent-blacklist configuration commands.
Parameters (if any)
<error>
<error message>
Configuration Commands (s - z)
user-agent-blacklist
Description
Sets the do command.
Ends the current configuration
session and returns to privileged
EXEC mode.
Sets the error code between 400
and 599.
Sets the error message.
356