Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual page 207

Table 78 lists the related hlr-service-sccp-gtt configuration commands.
Table 78. Commands related to ruckus(config-hlr-service-sccp-gtt)
Syntax and Type
ruckus(config-hlr-service-sccp-
gtt)# addr-indicator
Type: Privileged
ruckus(config-hlr-service-sccp-
gtt)# do
Type: Privileged
ruckus(config-hlr-service-sccp-
gtt)# end
Type: Privileged
ruckus(config-hlr-service-sccp-
gtt)# exit
Type: Privileged
ruckus(config-hlr-service-sccp-
gtt)# help
Type: Privileged
ruckus(config-hlr-service-sccp-
gtt)# e164-address
Type: Privileged
ruckus(config-hlr-service-sccp-
gtt)# gt-indicator
Type: Privileged
ruckus(config-hlr-service-sccp-
gtt)# has-point-code
Type: Privileged
ruckus(config-hlr-service-sccp-
gtt)# has-ssn
Type: Privileged
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71292-001 Rev A
Parameters (if any)
[ 2 | 1 ]
<e164-address>
[ 2 | 1 ]
Configuration Commands (e - r)
Description
Sets the address indicator.
2: Route on SSN
1: Route on GT
Executes the do command.
Ends the current configuration
session and return to privileged
EXEC mode.
Exits from the EXEC.
Displays the help.
Address as per recommendations
E.164.
Sets the GT indicator to:
2: Global title includes
translation type, numbering
plan, encoding scheme and
nature of address indicator.
1: Global title includes
translation type only.
Sets the HAS point codes.
Enables HAS upstream or
downstream SSN.
hlr-service
207