Mvno - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

Table 102. Commands related to ruckus( config-mgmt-acl-rule ).
Syntax and Type
ruckus(config-mgmt-acl-rule)#
restriction
Type: Privileged

mvno

To create or update the MVNO configuration, use the following command.
ruckus(config)# mvno <name>
Syntax Description
This command uses the following syntax:
name: MVNO name
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# mvno mv1
Related Commands
• Table 103
• Table 104
• Table 105
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71292-001 Rev A
Parameters (if any)
range <ip> <ip>: Sets IP
range restriction with start
and end IP addresses
single <ip>: Sets single IP
restriction and IP address
subnet <ip> <mask>: Sets
the subnet restriction
along with network
address and subnet mask
lists the related mvno configuration commands.
lists the related mvno-admin configuration commands.
lists the related mvno admin radius configuration commands.
Configuration Commands (e - r)
Description
Sets the restriction
mvno
265