User-Role - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

user-role

To create and update the user role configuration, use the following command.
ruckus(config)# user-role <name>
Syntax Description
This command uses the following syntax:
name: Name of the user role
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# user-role user-role
ruckus(config-user-role)#
Related Commands
Table 132
Table 132. Commands related to ruckus(config-user-role)
Syntax and Type
ruckus(config-user-role)# allow-
wlan-type
Type: Privileged
ruckus(config-user-role)#
description
Type: Privileged
ruckus(config-user-role)# do
Type: Privileged
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
lists the related user-role configuration commands.
Parameters (if any)
<all>: Allows Zero IT
access to all WLANs
zones - Allows Zero IT
access to all WLANs in the
selected zones
<wlans>: Allows Zero IT
access to selected
WLANs
<description>
Configuration Commands (s - z)
Description
Sets the allowed resources.
Sets the description.
Sets the do command.
user-role
360