Ip-Support - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

ip-support

To update IP version support, use the following command.
ruckus(config)# ip-support <ipv4-ipv6> <ipv4-only>
Syntax Description
This command uses the following syntax:
ipv4-ipv6: To support both IPv4 and IPv6 versions
ipv4-only: To support IPv4 version only
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# ip-support ipv4-ipv6
ipsec-profile
To update IPsec profile configuration, use the following command.
ruckus(config)# ipsec-profile <name>
Syntax Description
This command uses the following syntax:
<name>: IPsec profile name
Default
This command has no default settings.
Command Mode
Config
Example
ruckus(config)# ipsec-profile xyz
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71292-001 Rev A
Configuration Commands (e - r)
ip-support
240