Ap-Auto-Tagging - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

Table 16 lists the related to ap-pre-prov configuration commands.
Table 16. Commands related to ruckus(config-ap-pre-prov)
Syntax and Type
ruckus(config-ap-pre-prov)# ip6
Type: Privileged
ruckus(config-ap-pre-prov)# ip6
address
Type: Privileged
ruckus(config-ap-pre-prov)# ip6
name-server
Type: Privileged

ap-auto-tagging

To setup critical access point auto tagging rules or to enable auto tagging critical
access points, use the following command:
ruckus(config)# ap-auto-tagging <enable>
ruckus(config)# ap-auto-tagging rule <daily-threshold <threshold> [ g | m ]>>
Syntax Description
This command uses the following syntax:
enable: Enable the auto tagging critical APs
rule: Select the auto tagging rule
daily-threshold: Daily traffic bytes that exceeds the threshold rule
g: Threshold value in gigabytes
m: Threshold value in megabytes
Default
This command has no default settings.
Command Mode
Config
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
Parameters (if any)
<ip>: IP address
<gateway>: Gateway
<primary-dns>: Primary
DNS.
<secondary-dns>
secondary: Secondary
DNS
Configuration Commands (a - d)
Description
Sets IPV6 network settings.
Sets the IPV6 address and
gateway.
Sets the primary or secondary
DNS.
ap-auto-tagging
62