Mitsubishi Electric CR750-Q Instruction Manual page 382

4MELFA-BASIC V
M_Spd/M_NSpd/M_RSpd
[Function]
Returns the speed information during XYZ and JOINT interpolation.
M_Spd: Currently set speed.
M_NSpd: Initial value (optimum speed control).
M_RSpd: Directive speed.
[Format]
Example)<Numeric Variable>=M_Spd [(<Equation>)]
Example)<Numeric Variable>=M_NSpd [(<Equation>)]
Example)<Numeric Variable>=M_RSpd [(<Equation>)]
[Terminology]
<Numeric Variable>
<Equation>
[Reference Program]
1 M1=M_Spd
2 Spd M_NSpd
[Explanation]
(1) M_RSpd returns the directive speed at which the robot is operating. When the servo-off condition, the
feedback speed is returned. At this time, even if the robot is stopping, the value may change between
- 0.01, to +0.01
(2) This can be used in M_RSpd multitask programs or with Wth and WthIf statements.
(3) This variable only reads the data.
4-362 Detailed explanation of Robot Status Variable
Specifies the numerical variable to assign.
1 to 32, Specifies the task slot number. If this parameter is omitted, the current
slot will be used as the default.
' M1 will contain the currently set speed.
' Reverts the speed to the optimum speed control mode.