Mitsubishi Electric CR750-Q Instruction Manual page 225

(9) The condition defined in this command is retained in a sub program called up by the CallP command.
When a new setting for this condition is defined in a sub program, it overwrites the previous setting.
(10) When the same number is set in <Monitoring No.> of this command as in <Monitoring No.> of the Def
Map command, the monitored condition set in the command which is executed last is valid (the one set
in the command which was executed previously is deleted).
(11) During monitoring by executing the GpsChk On command, the setting of target condition cannot be
changed in this command. The setting of condition can be changed after stopping monitoring by exe-
cuting the GpsChk Off command.
[Related instructions]
GpsChk (Get position
[Related system status variables]
M_Gps, P_Gps1 to P_Gps8
check), Def Map (Define mapping)
Detailed explanation of command words 4-205
4MELFA-BASIC V