Operation And Configuration Of The Control Unit; Service Buttons - Siemens SIDOOR ATD401W System Manual

4.9

Operation and configuration of the control unit

The service buttons can be used to operate the controller.
The following options are available to parameterize the controller.
1. Parameter assignment via the PROFIdrive PKW interface
2. Parameter assignment with the terminal module
3. Parameter assignment with additional units (SIDOOR Service Tool, SIDOOR Software
Kit)
Note
After the optimal parameter settings have been determined, note them in the configuration
protocol (see appendix Configuration record (Page 309)). Have this record to hand when you
call the Hotline.
Note
Parameter changes
Parameters should always be adjusted during normal operation with the door at standstill,
because the controller then accepts the values immediately.
As of V1.09: The parameter changes are also applied in initial mode with standstill of the
door.
4.9.1

Service buttons

Overview
①
②
③
④
Figure 4-8
ATD4xxW Door Controller for Industrial Applications
System Manual, 01/2017, A5E38080677-AB
7-segment display
Learn run button
Service button OPEN
Service button CLOSE
Overview of minimal editor
4.9 Operation and configuration of the control unit
Controllers
161