Binding Tests; Function Button On The Room Unit, Room Sensor, Meteo Sensor, Radio Repeater And Radiator Control Actuator - Siemens Synco living Operating Instructions Manual

Binding tests

The binding tests on the individual devices are triggered by briefly pressing
the function button (located under the battery compartment cover).
On the central apartment unit, every successful binding test is confirmed by 3
short acoustic signals. Also, the display shows an additional window with
information about the test just made.
The additional window stays on the display until it is confirmed with the Menu /
ok button or the Esc button, or until it is replaced by the new additional win-
dow next time the binding test is made.
During the binding tests, the LED on the individual devices is used for indicat-
ing the batteries' capacity or, in the case of the radio repeater, for indicating
mains voltage (refer to page 86).
Binding tests can be triggered on the following types of devices:
Room unit, room temperature sensor, meteo sensor, radio repeater,
radiator control actuator, heating circuit controller and multi-controller.
After the binding test, the radio repeater indicates telegram traffic with
an orange LED flashing for 2 hours.
Function button on the room unit, room sensor,
meteo sensor, radio repeater and
radiator control actuator
Room unit QAW910
LED
F
Room sensor QAA910, meteo sensor
QAC910, and radio repeater ERF910
LED
F
90 / 100
Siemens
Building Technologies
Radiator control actuator SSA955
LED
Synco™ living Operating instructions
Service
F
F = function button
LED = light emitting diode
CE1B2707en
23.08.2008