Parameter Assignment Using Additional Devices; Parameter Names - Siemens SIDOOR ATD401W System Manual

4.9.3

Parameter assignment using additional devices

Description
In addition to the parameter assignment options integrated in the controller, you can also
assign parameters via additional units. The following additional units are available for
parameter assignment:
● SIDOOR User Software
The SIDOOR User Software is part of the SIDOOR Software Kit. You will find a detailed
description of the SIDOOR Software Kit in the SIDOOR Software Kit Operating
Instructions (http://support.automation.siemens.com/WW/view/en/92711247).
● SIDOOR Service Tool
You will find a detailed description of the SIDOOR Service Tool in SIDOOR Service Tool
(Page 243).
4.9.4

Parameter names

Some of the parameter names are abbreviated in the software because of the limited
number of characters in the display. The full names of the parameters are used in this
manual.
The following table shows the full parameter names and the equivalent names used in the
software:
Full parameter name
Profile parameter
Slow end distance open
Slow start distance open
Slow start distance close
Slow end distance close
Maximum speed open
Slow end speed open
Slow start speed open
Slow initial speed open
Maximum speed close
Slow start speed close
Slow end speed close
Slow initial speed close
NDG speed (reduced)
Acceleration ramp open
Deceleration ramp close
Reversal ramp open/close
Acceleration ramp close
Deceleration ramp close
Reversal ramp close/open
ATD4xxW Door Controller for Industrial Applications
System Manual, 01/2017, A5E38080677-AB
4.9 Operation and configuration of the control unit
Parameter name as shown in the software
Slow end distance open
Slow start distance open
Slow start distance close
Slow end distance close
Maximum speed open
Slow end speed open
Slow start speed open
Slow initial speed open
Maximum speed close
Slow start speed close
Slow end speed close
Slow initial speed close
Nudging speed / NDG speed (redu)
Acceler. ramp open
Deceleration ramp open
Reversal ramp op/cl
Acceler. ramp close
Deceler. ramp close
Reversal ramp cl/op
Controllers
1)
167