Diagnostic And Maintenance; Operating State Display - Siemens SIDOOR ATD401W System Manual

Diagnostic and maintenance

10.1

Operating state display

Operating states are indicated on the "H401" 7-segment display or the "H1" digital display of
the control unit.
The SIDOOR ATD410W/ATD420W/ATD430W controllers additionally enable retrieval of
status information via the parameter r2100 ("status code").
The following operating states are shown:
Display Meaning
Info
0 Light barrier / pressure-sensitive edge interrupted
1)
6 Motor obstructed in the closing direction
c Obstruction while opening
d Door remains stationary during initialization run (no OPEN or CLOSE signal present, or door has reached
end position)
H Determination of parameters (learn run)
o Function OK
u Door closed
Fault
1 RAM, EEPROM or CPU error (system error)
2 Braking chopper defective
3 Error in the 2nd Shutdown route
4 Motor protection, maximum opening or closing time of 65 s has been exceeded
5 Motor undefined – no learn run carried out with this motor type
(If a different motor version is used, the learn run must be repeated at power on as described in these Op-
erating Instructions. See Table 4-30 Starting a learn run when the line voltage is applied (Page 163))
7 Error in pulse generator
8 OSSD (ESPE type 2 or pressure-sensitive edge) – Function test failed
9 Motor overcurrent
E Motor overvoltage
F Motor undervoltage
n Output stage defective
L Current measurement error
t Belt torn
U Max. mass to be moved:
ATD4xxW Door Controller for Industrial Applications
System Manual, 01/2017, A5E38080677-AB
10
273