Siemens SIDOOR ATD401W System Manual page 245

Operating principle
Action
1
2
3
4
5
Note
Parameter changes are accepted with the door at a complete stop or in the OPEN or
CLOSED position.
Risk of injury due to moving mechanical parts
After parameters have been changed, the permitted energies and forces have to be
checked by service staff and adjusted if they exceed their limit values. This has to be done
on the heaviest door in the entire system with the shaft door and cabin door coupled.
Menu navigation
You can find the menu navigation for the SIDOOR Service Tool in the section Navigation
structure in the SIDOOR Service Tool (Page 246).
ATD4xxW Door Controller for Industrial Applications
System Manual, 01/2017, A5E38080677-AB
Select required parameter
Activate parameter for setting
using the Return key
Increase or decrease parameter
value
Accept parameter value by press-
ing Return key again
Select the next parameter
•
(Step 1)
or
exit the menu
•
WARNING
Key Remarks
Parameter value flashes
Displayed parameter value stops flashing
after acceptance.
-
SIDOOR Service Tool
7.3 Operation
245