Siemens SIDOOR ATD401W System Manual page 183

Parameter ID Adjustment range
p3867 0 ≙ deenergize
1 ≙ stop
2 ≙ open
3 ≙ close
p3868 0 ≙ deenergize
1 ≙ stop
2 ≙ open
3 ≙ close
Expert parameters, see Section Expert configuration (Page 75).
1)
The parameters in the table below refer to the opening direction only.
Table 4- 38 Obstruction and reversing parameters (in the opening direction)
Parameter ID Adjustment range
Timing
p3869 0 ... 60000
1)
p3870 0 ... 60000
1)
p3871 0 ... 60000
1)
Ranges
p3872 0 ... 60000
1)
p3873 0 ... 60000
1)
p3874 0 ... 60000
1)
p3875 0 ... 60000
1)
p3876 0 ... 60000
1)
Retries
p3877 0 to 0xFFFF
0 ≙ no retry
0xFFFF ≙ unlimited
retries
p3878 0 ... 60000
p3879 0 ≙ deenergize
1 ≙ stop
p3880 0 ≙ deenergize
1 ≙ stop
2 ≙ open
3 ≙ close
ATD4xxW Door Controller for Industrial Applications
System Manual, 01/2017, A5E38080677-AB
Factory set- Unit
ting
0 —
0 —
Factory setting Unit
1000 ms
500 ms
100 ms
20 mm
10 mm
10 mm
20 mm
50 mm
3 —
0 (V1.03 and
higher)
2000 ms
0 —
0 —
4.9 Operation and configuration of the control unit
Description
Drive control for obstruction while reversing
Drive control after all reverses have been execut-
ed
Description
ON-delay time for obstruction detection
Minimum detection time for stop obstruction
Minimum detection time for force obstruction
Distance for slow obstruction approach before
and after the obstruction
Range of suppression of obstruction detection
after the closed end stop
Range of suppression of obstruction detection
before the open end stop
Range of suppression of force obstruction detec-
tion before the creep distance
Range of suppression of force obstruction detec-
tion after the last obstruction
Number of retries to overcome the obstruction
Wait time before each retry
Drive control during the wait time (before retries)
Drive control after all retries have been executed
(if reversing is not configured)
Controllers
183