Digit Collection And Dial Plan Parameters - AudioCodes E-SBC User Manual

CHAPTER 68 Configuration Parameters Reference

Digit Collection and Dial Plan Parameters

The digit collection and dial plan parameters are described in the table below.
'Dial Plan Index'
configure voip > gateway dtmf-
supp-service dtmf-and-dialing
> dial-plan-index
[DialPlanIndex]
Parameter
Table 68-37:Digit Collection and Dial Plan Parameters
Parameter
Mediant 1000 Gateway & E-SBC | User's Manual
Description
■ [1] = During Call Establishment - DTMF digits
after * or # (inclusive) are sent as Keypad only
during call establishment and call disconnect.
During an established call, all digits are sent as
DTMF.
■ [2] = Always - DTMF digits after * or #
(inclusive) are always sent as Keypad (call
establishment, connect, and disconnect).
For more information, see
DTMFs for SIP-to-ISDN
Note:
■ This feature is not applicable to re-INVITE
messages.
■ The parameter is applicable only to digital
interfaces.
Defines the Dial Plan index to use in the external
Dial Plan file. The Dial Plan file is loaded to the
device as a .dat file (converted using the
DConvert utility). The Dial Plan index can be
defined globally or per Tel Profile.
The valid value range is 0 to 7, where 0 denotes
PLAN1, 1 denotes PLAN2, and so on. The default
is -1, indicating that no Dial Plan file is used.
Note:
■ If the parameter is configured to select a Dial
Plan index, the settings of the parameter
DigitMapping are ignored.
■ If the parameter is configured to select a Dial
Plan index from an external Dial Plan file, the
device first attempts to locate a matching digit
pattern in the Dial Plan file, and if not found,
then attempts to locate a matching digit
pattern in the Digit Map rules configured by
the DigitMapping parameter.
■ Digital interfaces: The parameter is also
applicable to ISDN with overlap dialing.
- 1226 -
Interworking Keypad
Calls.
Description