Configuring The Routing Tables; General Parameters; Figure 5-11: Routing Tables, General Parameters Screen; Table 5-10: Routing Tables, General Parameters (Continues On Pages 81 To 82) - AudioCodes MediaPack MP-108 User Manual

MediaPack SIP User's Manual
5.5.4

Configuring the Routing Tables

Use this submenu to configure the gateway's IP Tel and Tel IP routing tables and their
associated parameters.
5.5.4.1

General Parameters

Use this screen to configure the gateway's IP Tel and Tel IP routing parameters.
To configure the general parameters under Routing Tables, take these 4
steps:
Open the 'General Parameters' screen (Protocol Management menu > Routing Tables
1.
submenu > General option); the 'General Parameters' screen is displayed.
Configure the general parameters under 'Routing Tables' according to
2.
Click the Submit button to save your changes.
3.
To save the changes so they are available after a power fail, refer to Section
4.
161.

Table 5-10: Routing Tables, General Parameters (continues on pages 81 to 82)

Parameter
Add Hunt Group ID as Prefix
[AddTrunkGroupAsPrefix]
Add Port Number as Prefix
[AddPortAsPrefix]
Version 4.6

Figure 5-11: Routing Tables, General Parameters Screen

Description
No [0] = Don't add hunt group ID as prefix (default).
Yes [1] = Add hunt group ID as prefix to called number.
If enabled, then the hunt group ID is added as a prefix to the destination phone number
for Tel IP calls.
Note 1: This option can be used to define various routing rules.
Note 2: To use this feature you must configure the hunt group IDs.
No [0] = Disable the add port as prefix service (default).
Yes [1] = Enable the add port as prefix service.
If enabled, then the gateway's port number (single digit in the range 1 to 8 for 8-port
gateways, two digits in the range 01 to 24 in MP-124) is added as a prefix to the
destination phone number for Tel IP calls.
Note: This option can be used to define various routing rules.
81
5. Configuring the MediaPack
Table 5-10.
5.9 on page
June 2005