Setting Method - FUTABA 12K Instruction Manual

Setting method

When using motor speed function, move the
button to switch to the data input mode.
and push the RTN button.
push the RTN button to switch to the data
input mode.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
mode.
switch to the data input mode.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
mode.
push the RTN button to switch to the data
input mode.
and push the RTN button to set the one time
operation.
* When you want to reset one time operation, set the ACT/
INH item to [INH] and then reset it to [ON].
current position
<Model Menu (Airplane/Glider Functions)>
[START SW function example]
When the throttle (motor) stick is assigned as the "START SW",
and the low throttle position of the throttle curve is adjusted, the
motor starts operating with the initial stick movement. The motor
will not cease functionality even if the stick position is returned to
it's lowest setting.
Motor function, it is possible to turn the
motor off with the trim lever. To maintain
position accordingly in the programming of
the transmitter.
*Data Reset will return the trim setting to the off position.
you will note the presence of the small cursor
throttle stick to move the cursor accordingly.
When satisfied with this position, push and
hold the RTN button on the transmitter.
*The larger cursor is used to indicate the output of the motor
mixing which may be active.
curve screen opens.
*When a throttle function is assigned to either channel, the
"CURVE" button is not displayed because a throttle curve
does not function as a motor curve.
165