FUTABA 12K Instruction Manual page 164

MOTOR
This function lets you set the speed when the
motor of an F5B or other EP glider is started via
a switch. The operation speed can be set for two
ranges, slow speed flight and high speed flight
(Speed 1/Speed 2). This function can also be
operated as a safety function by programming it to
a switch.
and access the setup screen shown
below by pushing the RTN button.
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Setting method
When using this function, move the cursor to
RTN button.
cursor to the switch item and push the RTN
*For a description of the switch selection method, see the
description at the back of this manual.
and push the RTN button for one second
direction of the motor switch is memorized.
<Model Menu (Airplane/Glider Functions)>
164
the Linkage menu.
assigned to another channel, the changes from
the throttle channel to the motor channel are
enabled.
Note: Initial setting does not assign a motor
channel according to the model type. Prior to
channel. Then, use the Function menu of the
Linkage menu.
Set [Control] to the switch you want to use
and [Trim] to [--].
Note: When using this function, always check
the initial operation with the propeller
removed.
<Push Dial>
changes.
Note:
set the speed. When you want to reset the
motor OFF direction, also reset the speed.
combination with F/S.
Reverse function to match the ESC used.