FUTABA 12K Instruction Manual page 118

TELEMETRY : Servo sensor
The SBS-01S can monitor and display the in-
S.BUS2 servos.
If you forget to connect the servo wiring during
fuselage assembly, or the servo was disconnected,
an alarm can be activated at the transmitter.
RTN
HOME/EXIT
RETURN
Alert setting when servo #1 angle increases
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
Connect Alarm setting
If you forget to connect the servo wiring during
fuselage assembly, or the servo was disconnected,
an alarm can be activated at the transmitter.
*This alarm and display is limited to the S.BUS
servos connected to the servo sensors.
<Functions of Linkage Menu>
118
*SBS-01S must be installed in the aircraft.
[Angle]
*It cannot be used in S-FHSS mode
∼ °
*Alarm when the angle has decreased.
Alert setting when servo #1 angle decreases
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
<Push Dial>
∼ °
*Alarm when the angle has increased.
"Vibes" type
If the following types are selected, the
transmitter will vibrate during the warning.
TYPE 1
TYPE 2
TYPE 3
TYPE 4