FUTABA 12K Instruction Manual page 29

The T12K transmitter model data can be
stored by using any commonly found micro SD
card. When T12K transmitter update software is
released, the software is updated using a micro
SD card.
(Commercial product)
SD standard and SDHC standard microSD cards
SD/SDHC format. Maximum size 32MB. SDXC
format is not supported.
(Some models may not be operated by card.)
*The data in the memory card cannot be
guaranteed regardless of the contents and cause
of trouble or damage. Always back-up the
valuable data in the memory card.
Caution
Be sure to turn off the power to
the transmitter before inserting or
removing the micro SD card.
If the microSD card is removed while being
accessed (read or write), the card itself and the data
may be destroyed.
Do not install and remove the
microSD card with the microSD card
slot facing your face.
If you remove your fingers quickly, the microSD
card may fly out and strike your face and is
dangerous.
S i n c e t h e m i c r o S D c a r d i s a
precision device, do not subject it to
unreasonable force or shock.
As the micro SD card is a precision
device, do not use excessive force
when inserting.
Restrictions when using a micro SD card
The following restrictions apply when using a
micro SD card:
*The micro SD card must first be initialized using the
T12K dedicated format. The micro SD card cannot be
used as is without formatting to the T12K.
*Initializing destroys all the data previously saved on the
card.
*A micro SD card formatted to the T12K cannot be written
must be converted and written by the Futaba File System
This special conversion software can be downloaded from
Futaba's web site at:
http://www.futaba-rc.com/software-updates.html
Inserting/removing the micro SD card
1. Turn off the transmitter power and then
open the battery cover at the back side of
the transmitter.
2. The micro SD card slot is show here in the 2 Th i SD d l t i
microSD card slot
h h i th
<Before Use>
29