FUTABA 12K Instruction Manual page 80

SYSTEM
System Type selection
The T12K is for 2.4GHz only. The system can be
changed from among 2 choices: T-FHSS Air 14CH
and S-FHSS 8CH.
*If you change the System Type, other model data is not
reset.
*If a system type is changed in helicopter mode, the
transmitter will offer two selections:
[Yes] : Selection sets the channel order suitable for System
Type. (We recommend here. )
[No] : The present channel order is maintained.
*After any change, remember to test the model and should
fully check servo direction and a motion.
RTN
HOME/EXIT
RETURN
Battery fail-safe voltage setup (only T-FHSS Air )
The voltage which battery fail-safe activates,
can be set when you link. (3.5-8.4V) The receiver
memorizes the setting as it was at link.
Suggested setting voltages are as follows.
• 4 cells NiCd or NiMH (Normal: 4.8v) = 3.8 v
• 2 cells LiFe (Normal: 6.6 v) = 6.0 ~ 6.2 v
• 2 cells LiPo (Normal: 7.4 v) = 7.2 ~ 7.4 v
It is a rough reference value.
Since it changes with servos carried in the
condition and the model of a battery, please set to
your own model in a battery consumption current.
Cases when linking is necessary:
・
・
↔ )
・
Linking method
Telemetry function (T-FHSS Air mode only)
To use the telemetry function, set "Telemetry"
to "ACT".
<Functions of Linkage Menu>
80
Receiver linking
being affected by other transmitters) by the
transmitter it is linked to. When using a receiver
other than one purchased as a set, linking is
necessary.
model is added by model selection, and the time of
system type change.
P.42
The receiver will only be controlled (without
Moreover, a re-link is required when a new
<Push Dial>
System Type selection procedure
System T-FHSS Air S-FHSS