FUTABA 12K Instruction Manual page 160

When setting a rate selection switch, move
the cursor to the switch item and push the
RTN button to access the selection screen.
*For a description of the switch selection method, see the
description at the back of this manual.
Move the cursor to the gyro type selection
item and push the RTN button to switch to
and return to the cursor mode.
*When a Futaba GYA gyro is used and [GY] type is selected,
the sensitivity set value is directly read in both the AVCS
and NORM modes.
Move the cursor to the operation mode
5CH → GYRO
and TRIM → [--]
Rate
#1 AVCS : 60% AVCS : 60% AVCS : 60%
#2
#3 NORM : 60% NORM : 60% NORM : 60%
*Set so that Rate 1 is turned on at the back position of switch E and Rate 3 is turned ON at the front position. Since
switch E is turned OFF at the center, Rate 2 remains [INH].
Receiver
S.BUS/S.BUS2 port
<Model Menu (Airplane/Glider Functions)>
160
7CH → GYRO2
GYRO GYRO ２ GYRO ３
GYA441
Aileron servo
GYA441
Elevator servo
Rudder servo
GYA440
selection item and push the RTN button to
mode and return to the cursor mode.
Move the cursor to the sensitivity icon and
push the RTN button to switch to the data
input mode.
dial.
*When the RTN button is pushed for one second, the
sensitivity is reset to the initial value.)
mode.
8CH → GYRO3
TYPE ACT/INH
GY OFF/ON
INH
GY ON/OFF
AVCS
GAIN 0％
NORMAL
When AVCS is used we
recommend that the
sensitivity CH be set to
the 3-position.
CTRL
SW
SE
SE