FUTABA 12K Instruction Manual page 116

TELEMETRY : Servo sensor
The SBS-01S can monitor and display the
in-flight current, operating angle, and internal
temperature of up to two S.BUS2 servos.
If you forget to connect the servo wiring during
fuselage assembly, or the servo was disconnected,
an alarm can be activated at the transmitter.
RTN
HOME/EXIT
RETURN
*Alarm when the current has decreased.
Alert setting when servo #1 current increases
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
<Functions of Linkage Menu>
116
*SBS-01S must be installed in the aircraft.
[Current]
*It cannot be used in S-FHSS mode
∼
Alert setting when servo #1 current decreases
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
<Push Dial>
∼
*Alarm when the current has increased.
"Vibes" type
If the following types are selected, the
transmitter will vibrate during the warning.
TYPE 1
TYPE 2
TYPE 3
TYPE 4