FUTABA 12K Instruction Manual page 150

ELE to CAMBER
This function is used when you want to mix the
the flaps are lowered by up elevator, and lift is
increased.
and access the setup screen shown below
by pushing the RTN button.
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Setting method
the RTN button to switch to the data input
*The display blinks.
When setting a switch, move the cursor to
*For a description of the switch selection method, see the
description at the back of this manual.
<Model Menu (Airplane/Glider Functions)>
150
(Glider: Currently selected condition name)
<Push Dial>
*The display screen is an example.
The actual screen depends on the
model type.
Move the cursor to the up or down mixing
rate item for each servo and push the RTN
button to switch to the data input mode.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
hold the elevator stick to the desired position
button for one second to set the range.
*The mixing does not work near neutral of the elevator stick.