FUTABA 12K Instruction Manual page 65

Assigning models to the sensor buttons:
There are four sensors/buttons that correspond with
the Push Dial: Link (LNK), Model (MDL) System
(SYS) and S1. As such, it is possible to offer up
to four models available through the Quick Select
most often.
Using the sensors to select the model:
* Please note: Even if the Quick Select function is active, the
Power Mode screen will appear when the transmitter is turned
ON while simultaneously pushing the Return (RTN) button.
* If the Return (RTN) button is double-clicked, the T12K the
current model is selected as indicated on the display. That is,
the model that was used prior to the last time the transmitter
was turned OFF.
Model Select Screen
This allows the Model Select screen to be accessed
immediately upon turning ON the transmitter.
* Please note: this function cannot be utilized at the same time
as the Quick Select function. If more than four models are
utilized as it will save time when selecting the desired aircraft.
would be the best choice.
* Please note: the Model Select function does not allow access
to the RENAME, COPY or DELETE options. To utilize one
of these options, please access the Model Select screen in
the typical manner as described in the complete instruction
manual.
Model Select Activation:
With the Model Select (MODEL SEL.) option
activated, there are two additional options available
for customization; ALWAYS and MDL (Model).
These options determine if/when the Model Select
information will appear on-screen. ALWAYS,
as the name suggests, indicates that each time
the transmitter is powered-up, the Model Select
information will appear on-screen. The MDL
(Model) setting indicates that the Model Select
information will appear on-screen only when
the MDL button is pushed simultaneously as the
transmitter is turned ON.
With the Model Select mode highlighted, use the
<Functions of System Menu> 65