FUTABA 12K Instruction Manual page 138

THR CURVE
This function adjusts the throttle curve for
optimum engine speed from throttle stick input.
*When throttle curve is set to ON when there is no throttle
function; this curve acts as the motor function.
and access the setup screen shown
below by pushing the RTN button.
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Setting method
the RTN button to switch to the data input
mode.
dial.
*The display blinks.
and return to the cursor mode.
1. Move the cursor to the curve rate setting
button to switch to the data input mode.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
2. Repeat this procedure for each point.
1. Move the cursor to the curve point setting
<Model Menu (Airplane/Glider Functions)>
138
NOTE: If this throttle curve function is activated,
you can not use the THR-EXP function within
the DUAL RATE function simultaneously.
<Push Dial>
button to switch to the data input mode.
dial.
*When the RTN button is pushed for one second, the curve
position is reset to the initial value.)
and return to the cursor mode.
2. Repeat this procedure for each point.
Move the cursor to the curve point setting
RTN button for one second.