FUTABA 12K Instruction Manual page 154

Setting method
the RTN button to switch to the data input
*The display blinks.
When setting a switch, move the cursor to
*For a description of the switch selection method, see the
description at the back of this manual.
Move the cursor to the aileron, flap or
elevator rate item and push the RTN button
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
tune control
hardware
Operation Mode
displayed.
Mode : LIN. / ATL+ / ATL- / SYM.
*When Flying wing type, it was made not to display
BUTTERFLY ELE. (There is no elevator rate setting .)
<Model Menu (Airplane/Glider Functions)>
154
* The range where mixing does not work close to the neutral
position of the elevator stick can be adjusted. (Glider only)
*When offset is set, the curve is initialized.
and hold the airbrake stick to the desired
position and then push the RTN button for
one second to set the butterfly operational
reference point.
Move the cursor to the aileron, flap or
elevator speed item and push the RTN button
to switch to the data input mode.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
Range ： -100 ∼
+100%
Actual rate
Fine Tune Control