FUTABA 12K Instruction Manual page 159

GYRO
This function is used when a GYA Series gyro
is used to stabilize the aircraft's attitude. The
sensitivity and operation mode (Normal mode/
AVCS mode) can be changed via a switch.
switched.
simultaneously controlled.
access the setup screen shown below
by pushing the RTN button.
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
screen selection
selection
Setting method
*Prior to using the Function menu in the Linkage menu to
assign the sensitivity channel (Gyro/Gyro2/Gyro3) select an
unused channel.
Set [Control] and [Trim] other than function to [--].
Move the cursor to the setup screen selection
item and push the RTN button to switch
Note: This setting does not assign a sensitivity
channel. To do so, use the Linkage menu
prior to assigning the sensitivity channel
(Gyro/Gyro2/Gyro3), be sure to select an
unused channel.
Set the [Control] and [Trim] settings other than
Function to [--].
(Active rate # display)
can be set.
screen and return to the cursor mode.
the RTN button to switch to the data input
*The display blinks.
and return to the cursor mode.
<Model Menu (Airplane/Glider Functions)>
<Push Dial>
setting
：
GY type :
actual rate has not to be
NORM type :
actual rate has not to be greater
159