FUTABA 12K Instruction Manual page 146

RUD to AIL
This function is used when you want to mix
the ailerons with rudder input. It is used when
rudder is applied during roll maneuvers such
as, knife edge flight. It can be used to turn or
bank scale models, large models, etc. like a full-
size aircraft.
menu and access the setup screen
shown below by pushing the RTN
button.
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Setting method
the RTN button to switch to the data input
*The display blinks.
When setting a switch, move the cursor to
*For a description of the switch selection method, see the
description at the back of this manual.
<Model Menu (Airplane/Glider Functions)>
146
AIL1
(Main Aileron)
AIL 3
(Chip Aileron)
RUDDER 1
Winglet
( )
at Flying wing
V-TAIL
RUDDER 2
(Glider: Currently selected condition name)
*The display screen is an example.
Move the cursor to the left or right item
and push the RTN button to switch to the
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
To activate the link mixing, move the cursor
*The display blinks.
return to the cursor mode.
AIL 2
(Main Aileron)
AIL 3
(Chip Aileron)
RUDDER 2
Winglet
(
at Flying wing
RUDDER
RUDDER
<Push Dial>
The actual screen depends on the
model type.
)