FUTABA 12K Instruction Manual page 161

V-TAIL
This function enables adjustments for left and
right rudder angle changes during elevator and
rudder operation of a V-tail airplane.
V-tail is when two servos are used together to
control rudder movement as elevators. In addition
to each elevator side moving up and down together,
each side moves in opposite directions when moving
as rudders. On a V-tail, this is also known as a
Ruddervator, as they serve the same purpose.
access the setup screen shown below
by pushing the RTN button.
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
elevator operation
Setting method
Move the cursor to the item you want to
the data input mode.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
mode.
*If the mixing direction is reversed, adjustments can be made
by changing the mixing rate polarity (+ or -).
*If a large value of travel is specified, when the sticks are
moved at the same time, the controls may bind or run out of
travel. Decrease the travel until no binding occurs.
ELEVATOR
(RUDDER 2)
Left and right travel
operation
<Model Menu (Airplane/Glider Functions)>
RUDDER
(ELEVATOR 2)
<Push Dial>
161