FUTABA 12K Instruction Manual page 30

[Inserting the card]
Turn the micro SD card so that the front of
the card faces the rear of the transmitter
and slide the card into the card slot.
[Removing the card]
When the micro SD card is pressed in once
again, the card will be released from the
card slot. and can be removed.
3. Close the battery cover.
micro SD card initialization
To use a micro SD card with the T12K, the
card does not have to be reformatted. Formatting
is performed by the T12K.
[IMPORTANT] When a micro SD card is
formatted for the T12K, all pre-existing
data is destroyed. Do not format a card
containing important data.
[Formatting procedure]
1. Insert the micro SD card into the micro SD
card slot of the T12K.
2. T u r n o n t h e T 1 2 K p o w e r . W h e n a n
unformatted card is inserted into the T12K,
the screen shown below appears.
3. If the T12K is ready to format, move the
cursor to [FORMAT] and touch the RTN
button. (To cancel formatting, move the
cursor to [CANCEL] and touch the RTN
button.)
4. Move the cursor to [YES] and touch the RTN
button.
* Formatting starts. During formatting, the [NOW
FORMATTING...] message is displayed.
*When formatting is completed, The [FORMAT
COMPLETED] message is displayed. Depending on the
card capacity and speed, formatting may take as long as
several minutes.
30 <Before Use>
[IMPORTANT] Do not turn off the power until
the [FORMAT COMPLETED] message is
displayed.
5. End formatting by touching the RTN button.
micro SD card reader/writer
Saving model data and update files (released
from Futaba) to the micro SD card from your
transmitter. Equipment for reading and writing
micro SD cards is available at most electronics
stores.
Stored data
If you have a problem saving or reading data
after a long period of use, we suggest obtaining a
*Futaba is not responsible for compensating any failure or
damage to the data stored in the memory card. As such,
we suggest that you maintain a backup of your important
data contained on your micro SD card.