FUTABA 12K Instruction Manual page 158

Setting method
the RTN button to switch to the data input
*The display blinks.
When setting a switch, move the cursor to
the switch item and push the RTN button
*For a description of the switch selection method, see the
description at the back of this manual.
elevator rate item and push the RTN button
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
Move the cursor to the aileron, flap, rudder
or elevator speed item and push the RTN
button to switch to the data input mode.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
mode.
When setting a auto switch, move the cursor
*For a description of the switch selection method, see the
description at the back of this manual.
<Model Menu (Airplane/Glider Functions)>
158
stick or lever.
The start point of the mixing can be set.
Operated by the
stick or lever
Mode button
OFS : Offset mode
LIN : Linear mode
The screen of Offset mode
The start point this mixer is set.
< > is current position of MASTER.
At J1, J4, LD and RD, the left end
point is 0%, the right end point is
100%.
At J2, J3, LS, RS and SA~SH, the
upper end point is 100%, the lower
end point is 0%
The operation hardware is set.
The default setting is below;
Stick Mode 1 : J2
Stick Mode 2 : J3
e.g. Start point
J3: ＜ 50% ＞
Airbrake
doesn't move.
Low side
Air brake moves in
linear
Airbrake moves