FUTABA 12K Instruction Manual page 98

◆ The T12K writes a tiny file system to the micro SD
card. Please note the following information about
Data Logging.
* Approximately 0.3 sec is needed to write a new file
to the micro SD card. This means the actual start of
logging data is 0.3 Sec after the logging switch is turned
on.
* A maximum of 6393 records can be saved per file.
(Each record contains the elapsed time, CH data and the
telemetry data.)
* If the maximum of 6393 records is reached during the
logging process, the T12K will automatically create a
new file and continue to log data. Remember, if the
system takes approximately 0.3 sec to create the new
file. There will be a lapse in the logged data during that
period of time.
*The files name of the logged data on the micro SD card
are fixed, the first file will be labeled "LOG1".
If the logging ON/OFF switch is cycled during the same
flying session, the data will continue to be written to
TELEMETRY DATA LOG (icon)
The card icon indicates that the telemetry data logging function
<Functions of Linkage Menu>
98
This is a hardware for the pause switch of the telemetry
logging function.
If the pause switch is turned on while the telemetry data is
recorded, recording the telemetry data to the memory card
is stopped temporally. When the pause switch is turned off,
logging the telemetry data is resumed and recorded to same
LOG1. However, if the maximum number of records is
reached (6393) the system will create a new file named
"LOG2". If additional files are needed they will be name
sequentially, "LOG3", LOG4 and so on.
The logged elapsed time will continue to count in each
of the log files.
Log files may be merged after importing into a
spreadsheet or similar software.
* When the INTERVAL is 0sec, the actual interval time is
approximatly set to 0.1 Sec.
* FFS Ver.3.0 (free download) is necessary to export the
logged data from the micro SD card.
The "Export" function of FFS Ver. 3.0. creates a .cvs file
from the LOGx data file. The delimiter of the exported
files will be "comma" or "semi-colon" based on the
default setting of the PC used to import the data.
Caution
* Please do NOT use MODEL SELECT function while the
logging function is ON.
Logging data is stop.
Logging data is stop.
Logging data is running.
Logging data is running.