FUTABA 12K Instruction Manual page 169

FLT. MODE
In the FLT. MODE (flight mode), you can
change the multicopter mode to up to 3 CH, 5
signals set with any switch. It is used in the case of
a multicopter controller of the type that can change
and access the setup screen shown
below by pushing the RTN button.
setup screen shown below by pushing the RTN button.
Setting method
RTN button to switch to the data input mode.
● MODE
● MODE2
∼
● MODE3
*When the RTN button is pushed for one second, the rate is
direction.
*For a description of the switch selection method, see the
<Model Menu (Airplane/Glider Functions)>
<Model Menu (Multirotor Functions)>
possible for each function.
µ
ON during operation
<Push Dial>
selection switch. When
channel to be used for
reset to the initial value.)
and return to the cursor mode.
Move the cursor to the switch item and
push the RTN button to access the selection
description at the back of this manual.
µ
169