Resetting The Memory; Setting Method - FUTABA 8UHPS Instruction Manual

The Date Reset function is used to clear out an existing set of model data. This may
be used to input new model settings into a memory used for another model. It resets
all data to initial values.

Resetting the memory

Confirmation message "OK?"
To protect you against inadvertently resetting a model memory, a double setting (double push) system is
used. If the (-) key is pressed to halt resetting after the confirmation message is displayed, the display
returns to its original screen, and no changes are made.
NOTE: The existing modulation, model type, and trim display method settings are not reset. If the power
switch is turned off while a reset is underway, the data may not be reset.
The ATL trim function enables the trim lever to function only at the throttle stick idle
position and disables trim at high throttle, where it prevents pushrod jamming due to
trim changes made at idle.
Current setting (ON or
OFF displayed). Initial
value: ON.
The Engine Start function activate a switch which turns the (on-board) engine starter
on and off with switch H. The engine starter and snap roll functions cannot be used
simultaneously.

SETTING METHOD

Current setting display
(one of CH5, CH7, CH8
or INH). The default
setting is INH (inhibited).
To INVERT or SWASH
MODEL DATA RESET
Press both the (+) and (-) keys
simultaneously. The confirmation
message "OK?" is displayed at the
top left corner of the screen.
When both (+) and (-) are pressed
simultaneously again, the reset
process is begun. After a beep,
beep, beep tone is sounded, a
continuous beeeeep tone
indicates that the reset is
complete.
These keys are used to move through submenus in the PARA function.
To INVERTor SWASH
ATL ON/OFF setting
Select ON or OFF with the (+)
and (-) keys.
These keys are used to move through submenus in the PARA function.
To INVERT or SWASH function
EG/S Control channel setting:
Select the starter control
channel with the (+)/(-) keys.
34
These keys are used to
move through submenus in
function
the PARA function.
To REVERS
function
function
To REVERS function
To REVERS function
Data input keys
Data input keys
Data input keys